H3C Technologies H3C SecPath F1000-E - Manual (Page 463)

438
[RouterC-ospf-1] area 0
[RouterC-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.0] network 13.1.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.0] quit
[RouterC-ospf-1] quit
3. Configure BFD.
# Enable BFD on SecPath A and configure BFD parameters.
[SecPathA] bfd session init-mode active
[SecPathA] interface GigabitEthernet0/1
[SecPathA-GigabitEthernet0/1] ospf bfd enable
[SecPathA-GigabitEthernet0/1] bfd min-transmit-interval 500
[SecPathA-GigabitEthernet0/1] bfd min-receive-interval 500
[SecPathA-GigabitEthernet0/1] bfd detect-multiplier 7
[SecPathA-GigabitEthernet0/1] return
# Enable BFD on Router B and configure BFD parameters.
[RouterB] bfd session init-mode active
[RouterB] interface GigabitEthernet0/1
[RouterB-GigabitEthernet0/1] ospf bfd enable
[RouterB-GigabitEthernet0/1] bfd min-transmit-interval 500
[RouterB-GigabitEthernet0/1] bfd min-receive-interval 500
[RouterB-GigabitEthernet0/1] bfd detect-multiplier 6
4. Verify the configuration.
The following operations are performed on SecPath A. The operations on Router B are similar.
# Display the BFD information of SecPath A.
display bfd session
Total Session Num: 1 Init Mode: Active
Session Working Under Ctrl Mode:
LD/RD SourceAddr DestAddr State Holdtime Interface
3/1 192.168.0.102 192.168.0.100 Up 1700ms GigabitEthernet0/1
# Display routes to 120.1.1.0/24 on SecPath A, and you can see that SecPath A communicates
with Router B through the Layer 2 switch.
display ip routing-table 120.1.1.0 verbose
Routing Table : Public
Summary Count : 2
Destination: 120.1.1.0/24
Protocol: OSPF Process ID: 0
Preference: 0 Cost: 2
IpPrecedence: QosLcId:
NextHop: 192.168.0.100 Interface: GigabitEthernet0/1
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 0.0.0.0 Neighbor : 0.0.0.0
Tunnel ID: 0x0 Label: NULL
BKTunnel ID: 0x0 BKLabel: NULL
State: Active Adv Age: 00h58m10s
Tag: 0
Destination: 120.1.1.0/24
Protocol: OSPF Process ID: 1