H3C Technologies H3C SecPath F1000-E - Manual (Page 451)

426
[RouterA-ospf-1] area 1
[RouterA-ospf-1-area-0.0.0.1] stub no-summary
[RouterA-ospf-1-area-0.0.0.1] quit
# Display OSPF routing information on SecPath A.
[SecPathA] display ospf routing
OSPF Process 1 with Router ID 10.4.1.1
Routing Tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
0.0.0.0/0 4 Inter 10.2.1.1 10.2.1.1 0.0.0.1
10.2.1.0/24 3 Transit 10.2.1.2 10.4.1.1 0.0.0.1
10.4.1.0/24 3 Stub 10.4.1.1 10.4.1.1 0.0.0.1
Total Nets: 3
Intra Area: 2 Inter Area: 1 ASE: 0 NSSA: 0
NOTE:
After this configuration, route entries on the stub router are further reduced, containing only the default
external route.
Configuring an OSPF NSSA area at the CLI
Network requirements
Figure 271 shows an AS is split into three areas, where all routers run OSPF. Router A and Router B act
as ABRs to forward routing information between areas.
Configure Area 1 as an NSSA area, and configure SecPath as an ASBR to redistribute static routes into
the AS.
Figure 271 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown)
2. Configuring OSPF basic functions (see " Configuring OSPF basic functions at the CLI ").