H3C Technologies H3C SecPath F1000-E - Manual (Page 453)

428
Routing Tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
10.2.1.0/24 22 Inter 10.3.1.1 10.3.1.1 0.0.0.2
10.3.1.0/24 10 Transit 10.3.1.2 10.3.1.1 0.0.0.2
10.4.1.0/24 25 Inter 10.3.1.1 10.3.1.1 0.0.0.2
10.5.1.0/24 10 Stub 10.5.1.1 10.5.1.1 0.0.0.2
10.1.1.0/24 12 Inter 10.3.1.1 10.3.1.1 0.0.0.2
Routing for ASEs
Destination Cost Type Tag NextHop AdvRouter
3.1.2.0/24 1 Type2 1 10.3.1.1 10.2.1.1
Total Nets: 6
Intra Area: 2 Inter Area: 3 ASE: 1 NSSA: 0
The output shows that on Router C an external route imported from the NSSA area.
Configuring OSPF DR election at the CLI
Network requirements
In Figure 272 , Router A, Router B, SecPath A, and SecPath B are on the same network, running OSPF.
Configure SecPath A as the DR, and configure SecPath B as the BDR.
Figure 272 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown)
2. Configure OSPF basic functions:
# Configure SecPath A.
system-view
[SecPathA] router id 1.1.1.1
[SecPathA] ospf
[SecPathA-ospf-1] area 0
[SecPathA-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255
[SecPathA-ospf-1-area-0.0.0.0] quit
SecPath A Router A
SecPath B Router B
GE0/1
192.168.1.1/24 Eth1/1
192.168.1.2/24
GE0/1
192.168.1.3/24 Eth1/1
192.168.1.4/24