H3C Technologies H3C SecPath F1000-E - Manual (Page 377)

352
Item Description
Configuring inbound/outbound route filtering Optional
Configuring a priority for RIP Optional
Configuring RIP route redistribution Optional
Tuning and
optimizing RIP
networks
Configuring RIP timers Optional
Configuring split horizon and poison reverse Optional
Configuring the maximum number of ECMP routes Optional
Enabling zero field check on incoming RIPv1 messages Optional
Enabling source IP address check on incoming RIP updates Optional
Configuring RIPv2 message authentication Optional
Specifying a RIP neighbor Optional
Configuring RIP-to-MIB binding Optional
Configuring the RIP packet sending rate Optional
Configuring BFD for RIP Optional
Configuring RIP basic functions
Before you configure RIP basic functions, complete the following tasks:
• Configure the link layer protocol.
• Configure an IP address on each interface, and make sure all adjacent routers can reach each
other.
Enabling RIP and a RIP interface
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable a RIP process and enter
RIP view. rip [ process-id ] [ vpn-instance
vpn-instance-name ]
Disabled by default.
3. Enable RIP on the interface
attached to the specified
network. network network-address Disabled by default.
NOTE:
•
If you make some RIP configurations in interface view before enabling RIP, those configurations will take effect
after RIP is enabled.
• RIP runs only on the interfaces residing on the specified networks. Specify the network after enabling RIP to
validate RIP on a specific interface.
• You can enable RIP on all interfaces using the command network 0.0.0.0.
• If a physical interface is attached to multiple networks, you cannot advertise these networks in different RIP
processes.