Displaying bgp peer information – H3C Technologies H3C SecPath F1000-E User Manual
Page 469
444
Figure 277 Tabs on the BGP peer configuration page
2.
Click Add on the Peer Configuration tab.
The BGP peer configuration page appears.
Figure 278 Creating a BGP peer
3.
Configure the parameters as described in
.
Table 68 Configuration items
Item Description
Peer IP Address
Configure the IP address of the BGP peer.
Peer AS
Specify the AS number of the BGP peer.
Displaying BGP peer information
1.
Select Network > Routing Management > BGP from the navigation tree.
The BGP configuration page appears.
2.
After you complete BGP peer configurations, click Show Peer on the Show Information tab.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer