Configuring the dhcp server at the cli, Dhcp server configuration task list – H3C Technologies H3C SecPath F1000-E User Manual
Page 191
166
•
Set Lease Duration to 10 days, 12 hours, 0 minutes, and 0 seconds.
•
Enter 10.1.1.126 for Gateway Address.
•
Enter 10.1.1.4 for WINS Server Address.
•
Click Apply.
# Configure DHCP address pool 2 (address range, lease duration, and gateway).
•
Click Add and perform the following configuration, as shown in
Figure 101 Configuring DHCP address pool 2
•
Enter pool2 for IP Pool Name.
•
Enter 10.1.1.128 for IP Address.
•
Enter 255.255.255.128 for Mask.
•
Set Lease Duration to 5 days, 0 hours, 0 minutes, and 0 seconds.
•
Enter 10.1.1.254 for Gateway Address.
•
Click Apply.
Configuring the DHCP server at the CLI
DHCP server configuration task list
Complete the following tasks to configure the DHCP server:
Task Remarks
Configuring an address pool on the DHCP server
Required
Required
Enabling the DHCP server on an interface
Required
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer