Verifying the configuration, Configuring ddns at the cli, Ddns client configuration task list – H3C Technologies H3C SecPath F1000-E User Manual
Page 261
236
Figure 147 Configuring DDNS
2.
Enter 3322 in Domain Name.
3.
Select 3322.org from the Server Provider list.
4.
Enter steven in Username.
5.
Enter nevets in Password.
6.
Select GigabitEthernet0/1 from the Associated Interface list.
7.
Enter whatever.3322.org in FQDN.
8.
Click Apply.
Verifying the configuration
After the preceding configuration is completed, the SecPath will notify the DNS server of its new domain
name-to-IP address mapping through the DDNS server provided by www.3322.org whenever its IP
address changes. Therefore, the SecPath can always provide Web service at whatever.3322.org.
Configuring DDNS at the CLI
DDNS client configuration task list
Task Remark
Required
Applying the DDNS policy to an interface
Required
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer