Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 349
324
Figure 230 Network diagram
Configuration procedure
# Configure a CAR list.
•
Select Firewall > Traffic Policing > CAR List from the navigation tree, and click Add. Add a CAR list
as shown in
Figure 231 Configuring a CAR list
•
Enter 1 as the CAR list index.
•
Select Source IP from the IP Type list.
•
Select IP Range from the IP Set list.
•
Enter 2.1.1.1 as the start IP address.
•
Enter 2.1.1.100 as the end IP address.
•
Select Enable from the Limit Rate Per IP Address list.
•
Select Enable from the Share Bandwidth list.
•
Click Apply.
# Apply the CAR list to the interface.
•
Select Firewall > Traffic Policing > Apply from the navigation tree, and click Apply Policy. Apply the
CAR list as shown in
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer