Configuring join/prune message sizes, Displaying and maintaining pim – H3C Technologies H3C SecPath F1000-E User Manual
Page 654

629
Step
Command
Remarks
3.
Configure the hello interval.
pim timer hello interval
Optional.
30 seconds by default.
4.
Configure the maximum delay
between hello messages.
pim triggered-hello-delay interval
Optional.
5 seconds by default.
5.
Configure the join/prune interval. pim timer join-prune interval
Optional.
60 seconds by default.
6.
Configure the join/prune timeout
time.
pim holdtime join-prune interval
Optional.
210 seconds by default.
7.
Configure assert timeout time.
pim holdtime assert interval
Optional.
180 seconds by default.
NOTE:
If no special networking requirements are raised, use the default settings.
Configuring join/prune message sizes
A larger join/prune message size will result in loss of a larger amount of information if a message is lost;
with a reduced join/message size, the loss of a single message brings relatively minor impact.
By controlling the maximum number of (S, G) entries in a join/prune message, you can effectively reduce
the number of (S, G) entries sent per unit of time.
To configure join/prune message sizes:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter public network PIM view.
pim
N/A
3.
Configure the maximum size of a
join/prune message.
jp-pkt-size packet-size
Optional.
8100 bytes by default.
4.
Configure the maximum number
of (S, G) entries in a join/prune
message.
jp-queue-size queue-size
Optional.
4096 by default.
Displaying and maintaining PIM
Task
Command
Remarks
Display BSR information in the PIM-SM
domain and locally configured C-RP
information in effect.
display pim bsr-info [ | { begin |
exclude | include } regular-expression ] Available in any view
Display information about the unicast
routes used by PIM.
display pim claimed-route
[ source-address ] [ | { begin | exclude
| include } regular-expression ]
Available in any view
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer