H3C Technologies H3C SecPath F1000-E - Manual (Page 739)

714
Step Command Remarks
2. Create a DHCPv6 address
pool and enter DHCPv6
address pool view.
ipv6 dhcp pool pool-number
Not configured by
default.
3. .Configure a prefix.
• (Approach 1) Configure a static prefix
static-bind prefix prefix/prefix-len duid
duid [ iaid iaid ] [ preferred-lifetime
preferred-lifetime valid-lifetime
valid-lifetime ]
• (Approach 2) Apply a prefix pool to the
address pool
prefix-pool prefix-pool-number
[ preferred-lifetime preferred-lifetime
valid-lifetime valid-lifetime ]
Use either approach.
No prefix is specified by
default.
4. Configure a DNS server
address.
dns-server ipv6-address
Not configured by
default.
5. Configure a domain name. domain-name domain-name
Not configured by
default.
6. Configure the IPv6 address
or domain name of a SIP
server.
sip-server { address ipv6-address |
domain-name domain-name } Not configured by
default.
7. Specify the AFTR address. ds-lite address ipv6-address Not specified by default.
NOTE:
•
Only one prefix pool can be referenced by an address pool.
• A non-existing prefix pool can be referenced by an address pool. However, no prefix is available in the
prefix pool for dynamic prefix assignment until the prefix pool is created.
• You cannot modify the prefix pool referenced by an address pool, or the preferred lifetime or valid
lifetime by using the prefix-pool command. You need to remove the configuration before you can have
another prefix pool referenced by the address pool, or modify the preferred lifetime and valid lifetime.
• You can configure up to eight DNS server addresses, one domain name, eight SIP server addresses, and
eight SIP server domain names in an address pool.
• For more information about AFTR, see VPN Configuration Guide.
Applying the address pool to an interface
After an address pool is applied to an interface, a prefix and other configuration parameters can be
selected from the address pool and assigned to the DHCPv6 client requesting through the interface.
To apply an address pool to an interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view. interface interface-type interface-number N/A