H3C Technologies H3C SecPath F1000-E - Manual (Page 826)

801
Configuring IPv6 BGP peer group
Configuring an IBGP peer group
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Create an IBGP peer group. group ipv6-group-name [ internal ] N/A
5. Add a peer into the group.
peer ipv6-address group
ipv6-group-name [ as-number
as-number ]
Not added by default.
Creating a pure EBGP peer group
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Create an EBGP peer group. group ipv6-group-name external N/A
5. Configure the AS number for
the peer group.
peer ipv6-group-name as-number
as-number
Not configured by default.
6. Add an IPv6 peer into the
peer group. peer ipv6-address group
ipv6-group-name
Not added by default.
NOTE:
•
To create a pure EBGP peer group, you need to specify an AS number for the peer group.
• If a peer was added into an EBGP peer group, you cannot specify any AS number for the peer group.
Creating a mixed EBGP peer group
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Create an EBGP peer group. group ipv6-group-name external N/A
5. Specify the AS number of an
IPv6 peer. peer ipv6-address as-number
as-number
Not specified by default.