Configuring bims server information for the client, Configuring gateways for the client – H3C Technologies H3C SecPath F1000-E User Manual
Page 197
172
Step Command
Remarks
2.
Enter DHCP address pool
view.
dhcp server ip-pool pool-name
[ extended ]
N/A
3.
Specify WINS server IP
addresses.
nbns-list ip-address&<1-8>
Optional for b-node.
No address is specified by default.
4.
Specify the NetBIOS node
type.
netbios-type { b-node | h-node
| m-node | p-node }
Not specified by default.
Configuring BIMS server information for the client
Some DHCP clients perform regular software update and backup by using configuration files obtained
from a branch intelligent management system (BIMS) server. Therefore, the DHCP server needs to offer
these DHCP clients the BIMS server IP address, port number, shared key from the DHCP address pool.
To configure the BIMS server IP address, port number, and shared key in the DHCP address pool:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter DHCP address pool
view.
dhcp server ip-pool pool-name
[ extended ]
N/A
3.
Specify the BIMS server IP
address, port number, and
shared key.
bims-server ip ip-address [ port
port-number ] sharekey key
Not specified by default.
Configuring gateways for the client
You can specify up to eight gateways in a DHCP address pool.
To configure the gateways in the DHCP address pool:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter DHCP address pool
view.
dhcp server ip-pool pool-name
[ extended ]
N/A
3.
Specify gateways.
gateway-list ip-address&<1-8>
No gateway is specified by
default.
Configuring Option 184 parameters for the client with voice service
To assign voice calling parameters along with an IP address to DHCP clients with voice service, you need
to configure Option 184 on the DHCP server. For more information about Option 184, see "DHCP
overview."
If Option 55 in the request from a DHCP client contains Option 184, the DHCP server will return
parameters specified in Option 184 to the client. The client then can initiate a call using parameters in
Option 184.
To configure option 184 parameters in the DHCP address pool:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer