Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual

Page 546

521

Figure 297 Network diagram

Configuration procedure

Configure IP addresses for interfaces. (Details not shown.)

Configure IS-IS:
# Configure SecPath A.

system-view

[SecPathA] isis 1

[SecPathA-isis-1] is-level level-1

[SecPathA-isis-1] network-entity 10.0000.0000.0001.00

[SecPathA-isis-1] quit

[SecPathA] interface GigabitEthernet 4/1

[SecPathA-GigabitEthernet4/1] isis enable 1

[SecPathA-GigabitEthernet4/1] quit

# Configure SecPath B.

system-view

[SecPathB] isis 1

[SecPathB-isis-1] is-level level-1

[SecPathB-isis-1] network-entity 10.0000.0000.0002.00

[SecPathB-isis-1] quit

[SecPathB] interface GigabitEthernet 4/1

[SecPathB-GigabitEthernet4/1] isis enable 1

[SecPathB-GigabitEthernet4/1] quit

# Configure SecPath C.

system-view

[SecPathC] isis 1

[SecPathC-isis-1] network-entity 10.0000.0000.0003.00

[SecPathC-isis-1] quit

[SecPathC] interface GigabitEthernet 4/1

[SecPathC-GigabitEthernet4/1] isis enable 1

[SecPathC-GigabitEthernet4/1] quit

[SecPathC] interface GigabitEthernet 4/2

[SecPathC-GigabitEthernet4/2] isis enable 1

[SecPathC-GigabitEthernet4/2] quit

This manual is related to the following products: