H3C Technologies H3C SecPath F1000-E - Manual (Page 500)

475
Resetting BGP connections
Task Command Remarks
Reset all BGP connections. reset bgp all Available in user view
Reset the BGP connections to an AS. reset bgp as-number Available in user view
Reset the BGP connection to a peer. reset bgp ip-address [ flap-info ] Available in user view
Reset all EBGP connections. reset bgp external Available in user view
Reset the BGP connections to a peer
group.
reset bgp group group-name Available in user view
Reset all IBGP connections. reset bgp internal Available in user view
Reset all IPv4 unicast BGP
connections.
reset bgp ipv4 all Available in user view
Clearing BGP information
Task Command Remarks
Clear dampened MBGP routing
information and release suppressed
routes.
reset bgp dampening [ ip-address
[ mask | mask-length ] ]
Available in user view
Clear route flap information.
reset bgp flap-info [ ip-address
[ mask-length | mask ] | as-path-acl
as-path-acl-number | regexp
as-path-regular-expression ]
BGP basic configuration at the CLI
Network requirements
In Figure 288 , run EBGP between SecPath A and SecPath B and IBGP between SecPath B and SecPath
C so that SecPath C can access the network 8.1.1.0/24 connected to SecPath A.
Figure 288 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown)
2. Configure IBGP:
{
To prevent route flapping caused by port state changes, this example uses loopback interfaces
to establish IBGP connections.