H3C Technologies H3C SecPath F1000-E - Manual (Page 831)

806
IPv6 BGP basic configuration example
Network requirements
All firewalls in Figure 388 run IPv6 BGP. Between SecPath A and SecPath B is an EBGP connection.
SecPath B, SecPath C and SecPath D are fully meshed through IBGP connections.
Figure 388 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure IBGP connections:
# Configure SecPath B.
system-view
[SecPathB] ipv6
[SecPathB] bgp 65009
[SecPathB-bgp] router-id 2.2.2.2
[SecPathB-bgp] ipv6-family
[SecPathB-bgp-af-ipv6] peer 9:1::2 as-number 65009
[SecPathB-bgp-af-ipv6] peer 9:3::2 as-number 65009
[SecPathB-bgp-af-ipv6] quit
[SecPathB-bgp] quit
# Configure SecPath C.
system-view
[SecPathC] ipv6
[SecPathC] bgp 65009
[SecPathC-bgp] router-id 3.3.3.3
[SecPathC-bgp] ipv6-family
[SecPathC-bgp-af-ipv6] peer 9:3::1 as-number 65009
[SecPathC-bgp-af-ipv6] peer 9:2::2 as-number 65009
[SecPathC-bgp-af-ipv6] quit
[SecPathC-bgp] quit
# Configure SecPath D.
system-view
[SecPathD] ipv6
[SecPathD] bgp 65009
[SecPathD-bgp] router-id 4.4.4.4
[SecPathD-bgp] ipv6-family