H3C Technologies H3C SecPath F1000-E - Manual (Page 433)

408
Specifying the LSA arrival interval
After receiving the same LSA as the previously received LSA within the LSA arrival interval, OSPF discards
the LSA.
To configure the LSA arrival interval:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] *
N/A
3. Configure the LSA arrival
interval.
lsa-arrival-interval interval
Optional.
1000 milliseconds by default.
NOTE:
The interval set with the lsa-arrival-interval command should be smaller than or equal to the interval set
with the lsa-generation-interval command.
Specifying the LSA generation interval
You can adjust the LSA generation interval to protect network resources and routers from being over
consumed due to frequent network changes.
To configure the LSA generation interval:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] * N/A
3. Configure the LSA generation
interval.
lsa-generation-interval
maximum-interval [ initial-interval
[ incremental-interval ] ]
Optional.
By default, the maximum
interval is 5 seconds, the
minimum interval is 0
milliseconds and the
incremental interval is 5000
milliseconds.
NOTE:
When network changes are not frequent, LSAs are generated at the minimum-interval. If network changes
become frequent, the LSA generation interval is incremented by incremental-interval × 2 n-2 (n is the
number of generation times) each time a LSA generation occurs until the maximum-interval is reached.
Disabling interfaces from receiving and sending OSPF packets
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] *
N/A