H3C Technologies H3C SecPath F1000-E - Manual (Page 481)

456
Step Command Remarks
3. Configure the maximum
number of prefixes allowed
to be received from a
peer/peer group.
• Specify the maximum number of
prefixes that can be received
from a peer/peer group:
peer { group-name |
ip-address } route-limit
prefix-number
[ percentage-value ]
• Specify the maximum number of
prefixes that can be received
from a peer/peer group:
peer { group-name |
ip-address } route-limit
prefix-number alert-only
[ percentage-value ]
• Specify the maximum number of
prefixes that can be received
from a peer/peer group:
peer { group-name |
ip-address } route-limit
prefix-number reconnect
reconnect-time
[ percentage-value ]
Use one of the commands.
By default, no limit is configured.
For approach 1, if the number is
reached, the router breaks down
the BGP connection to the peer.
For approach 2, if the number is
reached, the router outputs alert
information but does not break
down the BGP connection to the
peer.
For approach 3, if the number is
reached, the router breaks down
the BGP connection to the peer and
then reestablishes a BGP
connection to the peer.
Configuring BGP route dampening
By configuring BGP route dampening, you can suppress unstable routes from being added to the local
routing table or being advertised to BGP peers.
To configure BGP route dampening:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Configure BGP route
dampening.
dampening [ half-life-reachable
half-life-unreachable reuse suppress
ceiling | route-policy
route-policy-name ] *
Not configured by default.
Configuring a shortcut route
An EBGP route received has a priority of 255, lower than a local route. This task allows you to configure
an EBGP route as a shortcut route that has the same priority as a local route and is more likely to become
the optimal route.
To configure a shortcut route:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A