H3C Technologies H3C SecPath F1000-E - Manual (Page 796)

771
[SecPathB-ospfv3-1] quit
[SecPathB] interface GigabitEthernet 0/1
[SecPathB-GigabitEthernet0/1] ospfv3 1 area 0
[SecPathB-GigabitEthernet0/1] quit
# Configure SecPath C.
system-view
[SecPathC] ipv6
[SecPathC] ospfv3
[SecPathC-ospfv3-1] router-id 3.3.3.3
[SecPathC-ospfv3-1] quit
[SecPathC] interface GigabitEthernet 0/1
[SecPathC-GigabitEthernet0/1] ospfv3 1 area 0
[SecPathC-GigabitEthernet0/1] quit
# Configure SecPath D.
system-view
[SecPathD] ipv6
[SecPathD] ospfv3
[SecPathD-ospfv3-1] router-id 4.4.4.4
[SecPathD-ospfv3-1] quit
[SecPathD] interface GigabitEthernet 0/1
[SecPathD-GigabitEthernet0/1] ospfv3 1 area 0
[SecPathD-GigabitEthernet0/1] quit
# Display neighbor information on SecPath A. You can find the firewalls have the same default DR
priority 1. Then, SecPath D (the firewall with the highest router ID) is elected as the DR, and SecPath
C is the BDR.
[SecPathA] display ospfv3 peer
OSPFv3 Area ID 0.0.0.0 (Process 1)
----------------------------------------------------------------------
Neighbor ID Pri State Dead Time Interface Instance ID
2.2.2.2 1 2-Way/DROther 00:00:36 GE0/1 0
3.3.3.3 1 Full/Backup 00:00:35 GE0/1 0
4.4.4.4 1 Full/DR 00:00:33 GE0/1 0
# Display neighbor information on SecPath D. You can find the neighbor states of SecPath D are
all full.
[SecPathD] display ospfv3 peer
OSPFv3 Area ID 0.0.0.0 (Process 1)
----------------------------------------------------------------------
Neighbor ID Pri State Dead Time Interface Instance ID
1.1.1.1 1 Full/DROther 00:00:30 GE0/1 0
2.2.2.2 1 Full/DROther 00:00:37 GE0/1 0
3.3.3.3 1 Full/Backup 00:00:31 GE0/1 0
3. Configure DR priorities for interfaces:
# Configure the DR priority of GigabitEthernet 0/1 of SecPath A as 100.
[SecPathA] interface GigabitEthernet 0/1
[SecPathA-GigabitEthernet0/1] ospfv3 dr-priority 100
[SecPathA-GigabitEthernet0/1] quit
# Configure the DR priority of GigabitEthernet 0/1 as 0 on SecPath B.