H3C Technologies H3C SecPath F1000-E - Manual (Page 161)

136
• A diagnostic PPPoE session is established immediately after the device configurations finish, and
automatically terminates and then tries to re-establish at a pre-configured interval. By establishing
and terminating PPPoE sessions periodically, you can monitor the working status of the PPPoE links.
To configure a PPPoE session:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Ethernet interface view. interface ethernet interface-number N/A
3. Create a PPPoE session, and specify
a dialer bundle for the session.
pppoe-client dial-bundle-number number
[ no-hostuniq ] [ idle-timeout seconds
[ queue-length packets ] ]
By default, no
PPPoE sessions are
created.
NOTE:
•
You can establish multiple PPPoE sessions on an Ethernet interface, which means, an Ethernet interface
can belong to multiple dialer bundles at the same time, but a dialer bundle can only have one Ethernet
interface. A PPPoE session uniquely corresponds to a dialer bundle, vise versa.
• IPv6 PPPoE sessions cannot be packet-triggered PPPoE sessions.
Resetting or terminating a PPPoE session
Step Command Remarks
1. Reset a PPPoE session on a
PPPoE client.
reset pppoe-client { all |
dial-bundle-number number }
Available in user view
2. Terminate a PPPoE session on
a PPPoE client. undo pppoe-client dial-bundle-number
number
Available in Ethernet
interface view or virtual
Ethernet interface view
Displaying and maintaining PPPoE
Task Command Remarks
Display the statistics and state
information about a PPPoE client.
display pppoe-client session { packet |
summary } [ dial-bundle-number
number ] [
| { begin | exclude | include }
regular-expression ]
Available in any view
PPPoE client configuration example at the CLI
Network requirements
As shown in Figure 73 , configure the router to authenticate the SecPath by using PAP or CHAP.