H3C Technologies H3C SecPath F1000-E - Manual (Page 360)

335
Figure 235 Network diagram
Configuration considerations
1. On SecPath A, configure a static route to SecPath B.
2. On SecPath B, configure two static routes to SecPath A and SecPath C.
3. On SecPath C, configure a static route to SecPath B.
Configuration procedure
1. Configure IP addresses of hosts and gateways:
As shown in
Figure 235 , configure IP addresses of the hosts, and configure the default gateways
of Host A, Host B and Host C as 1.1.2.3, 1.1.6.1 and 1.1.3.1. (Details not shown)
2. Configure IP address of the interfaces and security zones. (Details not shown)
3. Configure a static route on SecPath A:
a. Select Network > Routing Management > Static Routing from the navigation tree.
b. Click Add.
The page for configuring a static route appears.
Figure 236 Configuring a static route on SecPath A
c. Enter 0.0.0.0 as the destination IP address, select 0.0.0.0 from the mask list, and Enter 1.1.4.2
as the next hop.