H3C Technologies H3C SecPath F1000-E User Manual
Page 777
752
[SecPathC-ipsec-policy-manual-policy001-10] quit
4.
Apply the IPsec policies in the RIPng process:
# Configure SecPath A.
[SecPathA] ripng 1
[SecPathA-ripng-1] enable ipsec-policy policy001
[SecPathA-ripng-1] quit
# Configure SecPath B.
[SecPathB] ripng 1
[SecPathB-ripng-1] enable ipsec-policy policy001
[SecPathB-ripng-1] quit
# Configure SecPath C.
[SecPathC] ripng 1
[SecPathC-ripng-1] enable ipsec-policy policy001
[SecPathC-ripng-1] quit
5.
Verify the configuration:
RIPng packets between SecPath A, B and C are protected by IPsec.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer