H3C Technologies H3C SecPath F1000-E - Manual (Page 696)

671
[SecPathA] display pim routing-table
No information is output on SecPath A.
# Display PIM routing information on SecPath B.
[SecPathB] display pim routing-table
Total 1 (*, G) entry; 1 (S, G) entry
(*, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: WC
UpTime: 00:12:07
Upstream interface: Register
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet0/1
Protocol: igmp, UpTime: 00:12:07, Expires: -
(10.110.6.100, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: SPT 2MSDP ACT
UpTime: 00:40:22
Upstream interface: GigabitEthernet0/2
Upstream neighbor: 10.110.4.2
RPF prime neighbor: 10.110.4.2
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet0/1
Protocol: pim-sm, UpTime: - , Expires: -
SA message filtering configuration
Network requirements
As shown in Figure 352 , three PIM-SM domains exist in the network, and OSPF runs within and among
the domains to provide unicast routing.
Configure respective Loopback 0 of SecPath A, SecPath C and SecPath D as a C-BSR and C-RP in the
respective PIM-SM domain.
Set up an MSDP peering relationship between SecPath A and SecPath C and between SecPath C and
SecPath D.
Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Source 2 sends
multicast data to multicast group 227.1.1.0/30.
Configure SA message filtering rules so that receivers Host A and Host B can receive only the multicast
data addressed to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Host can receive only the
multicast data addressed to multicast groups 226.1.1.0/30 and 227.1.1.0/30.