H3C Technologies H3C SecPath F1000-E - Manual (Page 403)

378
RelyNextHop: 192.168.1.2 Neighbor : 192.168.2.2
Tunnel ID: 0x0 Label: NULL
BKTunnel ID: 0x0 BKLabel: NULL
State: Active Adv GotQ Age: 00h04m02s
Tag: 0
Destination: 100.1.1.0/24
Protocol: RIP Process ID: 2
Preference: 100 Cost: 2
IpPrecedence: QosLcId:
NextHop: 192.168.3.2 Interface: GigabitEthernet0/1
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 0.0.0.0 Neighbor : 192.168.3.2
Tunnel ID: 0x0 Label: NULL
BKTunnel ID: 0x0 BKLabel: NULL
State: Inactive Adv Age: 00h03m57s
Tag: 0
# Enable RIP event debugging on SecPath A. When the link between Router B and Router C fails,
SecPath A quickly detects the link state change.
debugging rip 1 event
terminal debugging
%Jan 19 10:41:51:203 2008 SecPathA BFD/4/LOG:Sess[192.168.1.1/192.168.2.2,
GigabitEthernet0/2, Ctrl], Sta: UP->DOWN, Diag: 1
*Jan 19 10:41:51:203 2008 SecPathA RM/6/RMDEBUG: RIP-BFD: Message Type Disable,
Connect Type Indirect-connect, Pkt Type Control, Src IP Address 192.168.1.1, Src
IFIndex 4, Nbr IP Address 192.168.2.2.
# Display the BFD information of SecPath A.
display bfd session
The output shows that SecPath A has deleted the neighbor relationship with Router C and no output
information is displayed.
# Display the RIP routes of RIP process 1 on SecPath A.
The RIP route learned from Router C is no longer existent.
display rip 1 route
Route Flags: R - RIP, T - TRIP
P - Permanent, A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------------------
# Display the RIP route 100.1.1.0/24 learned on SecPath A.
SecPathA> display ip routing-table 100.1.1.0 verbose
Routing Table : Public
Summary Count : 1
Destination: 100.1.1.0/24
Protocol: RIP Process ID: 2
Preference: 100 Cost: 2
IpPrecedence: QosLcId:
NextHop: 192.168.3.2 Interface: GigabitEthernet0/2
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 0.0.0.0 Neighbor : 192.168.3.2
Tunnel ID: 0x0 Label: NULL