H3C Technologies H3C SecPath F1000-E - Manual (Page 206)

181
You can use the display dhcp server ip-in-use command on the DHCP server to view the IP addresses
assigned to the clients.
Dynamic IP address assignment configuration example
Network requirements
• As shown in Figure 103 , the DHCP server (SecPath) assigns IP address to clients on subnet
10.1.1.0/24, which is subnetted into 10.1.1.0/25 and 10.1.1.128/25.
• The IP addresses of GigabitEthernet 0/1 and GigabitEthernet 0/2 on the SecPath are 10.1.1.1/25
and 10.1.1.129/25 respectively.
• In subnet 10.1.1.0/25, the address lease duration is ten days and twelve hours, domain name suffix
aabbcc.com, DNS server address 10.1.1.2/25, WINS server address 10.1.1.4/25, and gateway
address 10.1.1.126/25.
• In the subnet 10.1.1.128/25, the address lease duration is five days, domain name suffix
aabbcc.com, DNS server address 10.1.1.2/25, and gateway address 10.1.1.254/25 and there is
no WINS server address.
• The domain name suffix and DNS server address on subnets 10.1.1.0/25 and 10.1.1.128/25 are the
same. Therefore, the domain name suffix and DNS server address need to be configured only for
subnet 10.1.1.0/24. Subnet 10.1.1.0/25 and 10.1.1.128/25 can inherit the configuration of subnet
10.1.1.0/24.
Figure 103 Network diagram
Configuration procedure
• Specify IP addresses for interfaces. (Details not shown.)
• Configure the DHCP server
# Enable DHCP.
system-view
[SecPath] dhcp enable
# Enable the DHCP server on GigabitEthernet 0/1 and GigabitEthernet 0/2.
[SecPath] interface GigabitEthernet 0/1
[SecPath-GigabitEthernet0/1] dhcp select server global-pool
[SecPath-GigabitEthernet0/1] quit
[SecPath] interface GigabitEthernet 0/2
[SecPath-GigabitEthernet0/2] dhcp select server global-pool