H3C Technologies H3C SecPath F1000-E - Manual (Page 461)

436
10.4.1.0/24 OSPF 10 13 10.2.1.2 GE0/2
10.5.1.0/24 OSPF 10 14 10.1.1.2 GE0/1
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
The route destined for network 3.1.3.0/24 is filtered out.
5. Configure SecPath A to filter out route 10.5.1.1/24:
# Configure the ACL on SecPath A.
system-view
[SecPathA] acl number 2000
[SecPathA-acl-basic-2000] rule 0 deny source 10.5.1.0 0.0.0.255
[SecPathA-acl-basic-2000] rule 1 permit source any
[SecPathA-acl-basic-2000] quit
# Use the ACL to filter route 10.5.1.0/24.
[SecPathA] ospf 1
[SecPathA-ospf-1] filter-policy 2000 import
[SecPathA-ospf-1] quit
# Display the OSPF routing table of SecPath A.
[SecPathA] display ip routing-table
Routing Tables: Public
Destinations : 10 Routes : 10
Destination/Mask Proto Pre Cost NextHop Interface
3.1.1.0/24 O_ASE 150 1 10.2.1.2 GE0/2
3.1.2.0/24 O_ASE 150 1 10.2.1.2 GE0/2
10.1.1.0/24 Direct 0 0 10.1.1.1 GE0/1
10.1.1.1/32 Direct 0 0 127.0.0.1 InLoop0
10.2.1.0/24 Direct 0 0 10.2.1.1 GE0/2
10.2.1.1/32 Direct 0 0 127.0.0.1 InLoop0
10.3.1.0/24 OSPF 10 4 10.1.1.2 GE0/1
10.4.1.0/24 OSPF 10 13 10.2.1.2 GE0/2
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
The route to 10.5.1.1/24 is filtered out.
Configuring BFD for OSPF at the CLI
Network requirements
As shown in Figure 275 :
• OSPF is enabled on SecPath A, Router B and Router C so that they are reachable to each other at
the network layer.
• After the link over which SecPath A and Router B communicate through a Layer 2 switch fails, BFD
can quickly detect the failure and notify OSPF of the failure. SecPath A and Router B then
communicate through Router C.