H3C Technologies H3C SecPath F1000-E - Manual (Page 383)

358
To configure RIP route redistribution:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a default metric for
redistributed routes.
default cost value
Optional.
The default metric of a
redistributed route is 0.
4. Redistribute routes from another
protocol.
import-route protocol [ process-id |
all-processes | allow-ibgp ] [ cost
cost | route-policy route-policy-name
| tag tag ] *
By default, no redistribution is
configured.
NOTE:
Only active routes can be redistributed. Use the display ip routing-table protocol command to display
route state information.
Tuning and optimizing RIP networks
Before tuning and optimizing RIP networks, complete the following tasks:
• Configure network addresses for interfaces, and make sure that all neighboring nodes can reach
each other.
• Configure RIP basic functions.
Configuring RIP timers
You can change the RIP network convergence speed by adjusting RIP timers.
To configure RIP timers:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure values for RIP timers.
timers { garbage-collect
garbage-collect-value | suppress
suppress-value | timeout
timeout-value | update
update-value } *
Optional.
The default update timer,
timeout timer, suppress timer,
and garbage-collect timer are
30s, 180s, 120s, and 120s,
respectively.
NOTE:
Based on network performance, you must make RIP timers of RIP routers identical to each other to avoid
unnecessary traffic or route oscillation.