H3C Technologies H3C SecPath F1000-E - Manual (Page 694)

669
[SecPathA] interface GigabitEthernet 0/2
[SecPathA-GigabitEthernet0/2] pim sm
[SecPathA-GigabitEthernet0/2] quit
[SecPathA] interface GigabitEthernet 0/3
[SecPathA-GigabitEthernet0/3] pim sm
[SecPathA-GigabitEthernet0/2] quit
[SecPathA] interface loopback 0
[SecPathA-LoopBack0] pim sm
[SecPathA-LoopBack0] quit
[SecPathA] interface loopback 10
[SecPathA-LoopBack10] pim sm
[SecPathA-LoopBack10] quit
[SecPathA] interface loopback 20
[SecPathA-LoopBack20] pim sm
[SecPathA-LoopBack20] quit
The configuration on Router A, Router B, SecPath B, and Router C is similar to that on SecPath A.
3. Configure C-BSRs and C-RPs:
# Configure Loopback 10 as a C-BSR and configure Loopback 20 as a C-RP on SecPath A.
[SecPathA] pim
[SecPathA-pim] c-bsr loopback 10
[SecPathA-pim] c-rp loopback 20
[SecPathA-pim] quit
The configuration on SecPath B is similar to the configuration on SecPath A.
4. Configure MSDP peers:
# Configure an MSDP peer on Loopback 0 of SecPath A.
[SecPathA] msdp
[SecPathA-msdp] originating-rp loopback 0
[SecPathA-msdp] peer 2.2.2.2 connect-interface loopback 0
[SecPathA-msdp] quit
# Configure an MSDP peer on Loopback 0 of SecPath B.
[SecPathB] msdp
[SecPathB-msdp] originating-rp loopback 0
[SecPathB-msdp] peer 1.1.1.1 connect-interface loopback 0
[SecPathB-msdp] quit
5. Verify the configuration:
You can use the display msdp brief command to display brief information about the MSDP peering
relationship between the firewalls.
# Display brief MSDP peer information on SecPath A.
[SecPathA] display msdp brief
MSDP Peer Brief Information
Configured Up Listen Connect Shutdown Down
1 1 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
2.2.2.2 Up 00:10:17 ? 0 0
# Display brief MSDP peer information on SecPath B.