H3C Technologies H3C SecPath F1000-E - Manual (Page 162)

137
Figure 73 Network diagram
Configuration procedure
Configuring PAP authentication
1. Configure Router as the PPPoE server:
# Add a PPPoE user.
system-view
[Router] local-user user2
[Router-luser-user2] password simple hello
[Router-luser-user2] service-type ppp
[Router-luser-user2] quit
# Configure virtual template 1.
[Router] interface virtual-template 1
[Router-Virtual-Template1] ppp authentication-mode pap
[Router-Virtual-Template1] ip address 1.1.1.1 255.0.0.0
[Router-Virtual-Template1] remote address 1.1.1.2
[Router-Virtual-Template1] quit
# Configure the PPPoE server.
[Router] interface GigabitEthernet 0/1
[Router- GigabitEthernet 0/1] pppoe-server bind virtual-template 1
2. Configure SecPath as the PPPoE client:
system-view
[SecPath] dialer-rule 1 ip permit
[SecPath] interface dialer 1
[SecPath-Dialer1] dialer user user2
[SecPath-Dialer1] dialer-group 1
[SecPath-Dialer1] dialer bundle 1
[SecPath-Dialer1] ip address ppp-negotiate
[SecPath-Dialer1] ppp pap local-user user2 password simple hello
[SecPath-Dialer1] quit
# Configure the PPPoE session.
[SecPath] interface GigabitEthernet 0/1
[SecPath- GigabitEthernet 0/1] pppoe-client dial-bundle-number 1
Configuring CHAP authentication
1. Configure Router as the PPPoE server:
# Add a PPPoE user.
system-view
[Router] local-user user2
[Router-luser-user2] password simple hello