H3C Technologies H3C SecPath F1000-E - Manual (Page 139)

114
Step Command Remarks
4. Configure the PPP authentication
modes.
• Configuring PAP authentication
• Configuring CHAP
authentication
• Configuring MS-CHAP or
MS-CHAP-V2 authentication
Optional.
PPP authentication is
disabled by default.
You can configure several
authentication modes
simultaneously. In LCP
negotiation, the
authenticator negotiates with
the authenticatee in the
sequence of configured
authentication modes until
the LCP negotiation
succeeds. If the response
packet from the
authenticatee carries a
recommended authentication
mode, the authenticator
directly uses the
authentication mode if it finds
the mode configured.
5. Configure PPP negotiation. See " Configuring PPP negotiation ." Optional.
6. Enable PPP traffic statistics
collection.
See " Enabling PPP traffic statistics
collection ."
Optional.
7. Enable the ignoring of next-hop
address matching.
See " Enabling the ignoring of
next-hop address matching ."
Optional.
NOTE:
This chapter only discusses local authentication. For more information about the remote AAA
authentication, see
Access Control Configuration Guide.
Configuring PAP authentication
Configuring the authenticator
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a VT interface and
enter its view.
interface virtual-template number N/A
3. Configure the local device to
authenticate the peer by using
PAP.
ppp authentication-mode pap
[ [
call-in ] domain isp-name ]
By default, PPP authentication is
disabled.
4. Return to system view. quit N/A
5. Create a local user account
for the authenticatee and
enter local user view.
local-user username N/A