H3C Technologies H3C SecPath F1000-E - Manual (Page 606)

581
Figure 328 Network diagram
Configuring IP addresses and unicast routing
Configure the IP address of each interface and the security zone as per Figure 328 . (Details not shown.)
Enable OSPF on firewalls on the PIM network to make sure the network-layer on the PIM-DM network is
interoperable and the routing information among the firewalls can be dynamically updated. (Details not
shown.)
Configuring SecPath A
1. Enable IP multicast routing:
a. Select Network > Routing Management > Multicast Routing from the navigation tree to enter
the Global Configuration page, as shown in
Figure 329 .
b. Select Enable from the list to enable multicast routing.
c. Click Apply.
Figure 329 Enabling IP multicast routing
2. Enable PIM-DM on each interface:
a. Select Network > Routing Management > PIM from the navigation tree to enter the Interface
Configuration page.
b. Click the icon corresponding to GigabitEthernet 0/1 to enter its configuration page, as
shown in Figure 330 .
c. Specify the operating mode as PIM-DM and click Apply.
SecPath A
SecPath B
SecPath C
Querier
PIM network
N1
N2
Receiver
Receiver
Host A
Host B
Host C
Host D
GE0/1
10.110.1.1/24
GE0/1
10.110.2.1/24
GE0/1
10.110.2.2/24
GE0/2
GE0/2
GE0/2