H3C Technologies H3C SecPath F1000-E - Manual (Page 813)

788
Step Command Remarks
4. Specify the source interface
for establishing TCP
connections to an IPv6 BGP
peer or peer group.
peer { ipv6-group-name |
ipv6-address } connect-interface
interface-type interface-number
By default, IPv6 BGP uses the
outgoing interface of the best route
to the IPv6 BGP peer or peer group
as the source interface for
establishing a TCP connection.
Allowing the establishment of a non-direct EBGP connection
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family view. ipv6-family N/A
4. Allow the establishment of EBGP
connection to a non directly connected
peer/peer group.
peer { ipv6-group-name |
ipv6-address } ebgp-max-hop
[ hop-count ]
Not configured by
default.
NOTE:
In general, direct links should be available between EBGP peers. If not, you can use the peer
ebgp-max-hop command to establish a multi-hop TCP connection in between. However, you need not use
this command for direct EBGP connections with loopback interfaces.
Configuring a description for an IPv6 peer/peer group
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Configure a description for an
IPv6 peer/peer group. peer { ipv6-group-name | ipv6-address }
description description-text Optional.
Not configured by default.
NOTE:
The peer group to be configured with a description must have been created.
Disabling session establishment to an IPv6 peer/peer group
Step Command Remarks
1. Enter system view. system-view N/A