H3C Technologies H3C SecPath F1000-E - Manual (Page 600)

575
# Configure OSPF on SecPath B.
system-view
[SecPathB] ospf 1
[SecPathB-ospf-1] area 0
[SecPathB-ospf-1-area-0.0.0.0] network 20.1.1.0 0.0.0.255
[SecPathB-ospf-1-area-0.0.0.0] network 30.1.1.0 0.0.0.255
[SecPathB-ospf-1-area-0.0.0.0] quit
[SecPathB-ospf-1] quit
# Configure OSPF on SecPath C.
[SecPathC] ospf 1
[SecPathC-ospf-1] area 0
[SecPathC-ospf-1-area-0.0.0.0] network 30.1.1.0 0.0.0.255
[SecPathC-ospf-1-area-0.0.0.0] network 40.1.1.0 0.0.0.255
[SecPathC-ospf-1-area-0.0.0.0] network 50.1.1.0 0.0.0.255
[SecPathC-ospf-1-area-0.0.0.0] quit
[SecPathC-ospf-1] quit
4. Enable IP multicast routing, PIM-DM, and IGMP:
# Enable multicast routing on SecPath A and enable PIM-DM on each interface.
[SecPathA] multicast routing-enable
[SecPathA] interface GigabitEthernet 0/1
[SecPathA-GigabitEthernet0/1] pim dm
[SecPathA-GigabitEthernet0/1] quit
[SecPathA] interface GigabitEthernet 0/2
[SecPathA-GigabitEthernet0/2] pim dm
[SecPathA-GigabitEthernet0/2] quit
[SecPathA] interface tunnel 0
[SecPathA-Tunnel0] pim dm
[SecPathA-Tunnel0] quit
# Enable multicast routing on SecPath C, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 0/1.
[SecPathC] multicast routing-enable
[SecPathC] interface GigabitEthernet 0/1
[SecPathC-GigabitEthernet0/1] igmp enable
[SecPathC-GigabitEthernet0/1] pim dm
[SecPathC-GigabitEthernet0/1] quit
[SecPathC] interface GigabitEthernet 0/2
[SecPathC-GigabitEthernet0/2] pim dm
[SecPathC-GigabitEthernet0/2] quit
[SecPathC] interface tunnel 0
[SecPathC-Tunnel0] pim dm
[SecPathC-Tunnel0] quit
5. Configure a static multicast route:
# On SecPath C, configure a static multicast route and specify its RPF neighbor leading toward
Source is Tunnel 0 on SecPath A.
[SecPathC] ip rpf-route-static 10.1.1.0 24 50.1.1.1
6. Verify the configuration: