H3C Technologies H3C SecPath F1000-E - Manual (Page 495)

470
NOTE:
•
Do not specify any AS number for a peer before adding it into the peer group.
• Peers added in the group can have different AS numbers.
Configuring BGP community
A BGP community is a group of destinations with the same characteristics. It has no geographical
boundaries and is independent of ASs.
You can configure a routing policy to define which destinations belong to a BGP community and then
advertise the community attribute to a peer/peer group.
You can apply a routing policy to filter routes advertised to/received from a peer/peer group according
to the community attribute. This way helps simplify policy configuration and management.
For how to configure a routing policy, see "Configuring routing policies."
To configure BGP community:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Advertise the community
attribute to a peer/peer group.
• Advertise the community attribute
to a peer/peer group:
peer { group-name | ip-address }
advertise-community
• Advertise the extended
community attribute to a
peer/peer group:
peer { group-name | ip-address }
advertise-ext-community
Not configured by default.
Not configured by default.
4. Apply a routing policy to routes
advertised to a peer/peer
group.
peer { group-name | ip-address }
route-policy route-policy-name
export
Not configured by default.
Configuring a BGP route reflector
If an AS has many BGP routers, you can configure them as a cluster and configure one of them as a route
reflector and others as clients to reduce IBGP connections.
To enhance network reliability and prevent single point of failure, specify multiple route reflectors for a
cluster. The route reflectors in the cluster must have the same cluster ID to avoid routing loops.
To configure a BGP route reflector:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Configure the router as a route
reflector and specify a
peer/peer group as its client.
peer { group-name | ip-address }
reflect-client
Not configured by default.