H3C Technologies H3C SecPath F1000-E - Manual (Page 924)

899
Configuring the MLD version
Because MLD message types and formats vary with MLD versions, the same MLD version should be
configured for all routers on the same subnet before MLD can work properly.
Configuring an MLD version globally
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter MLD view. mld N/A
3. Configure an MLD version
globally.
version version-number MLDv1 by default
Configuring an MLD version on an interface
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an MLD version on
the interface.
mld version version-number MLDv1 by default
Configuring static joining
After an interface is configured as a static member of an IPv6 multicast group or an IPv6 multicast source
and group, it will act as a virtual member of the IPv6 multicast group to receive IPv6 multicast data
addressed to that IPv6 multicast group for the purpose of testing IPv6 multicast data forwarding.
To configure a static member of an IPv6 multicast group or an IPv6 multicast source and group:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure a static member of
an IPv6 multicast group or an
IPv6 multicast source and
group.
mld static-group
ipv6-group-address [ source
ipv6-source-address ]
By default, an interface is not a
static member of any IPv6 multicast
group or IPv6 multicast source and
group.