N in, Figure 6 – H3C Technologies H3C SecPath F1000-E User Manual
Page 34
9
Figure 6 Modifying interface GigabitEthernet 0/1
•
Select the Bridge mode option for the working mode item.
•
Click Apply.
# Change the working mode of GigabitEthernet 0/2 into bridge. (The configuration here is the same as
that for GigabitEthernet 0/1)
# Create VLAN-interface 1. By default, VLAN 1 exists and all ports are untagged members of VLAN 1.
•
On the interface management page, click Add, and make the following configurations, as shown
in
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer