H3C Technologies H3C SecPath F1000-E - Manual (Page 827)

802
Step Command Remarks
6. Add the IPv6 peer into the
peer group. peer ipv6-address group
ipv6-group-name
Not added by default.
NOTE:
When creating a mixed EBGP peer group, you need to create a peer and specify its AS number that can
be different from AS numbers of other peers; however, you cannot specify AS number for the EBGP peer
group.
Configuring IPv6 BGP community
Advertising community attribute to an IPv6 peer/peer group
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Advertise community attribute
to an IPv6 peer/peer group.
peer { ipv6-group-name |
ipv6-address }
advertise-community
Not advertised by default.
5. Advertise extended
community attribute to an IPv6
peer/peer group.
peer { ipv6-group-name |
ipv6-address }
advertise-ext-community
Not advertised by default.
Apply a routing policy to routes advertised to a peer/peer group
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Apply a routing policy to
routes advertised to an IPv6
peer/peer group.
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
Not applied by default.
NOTE:
•
When configuring IPv6 BGP community, you must configure a routing policy to define the community
attribute, and apply the routing policy to route advertisement.
• For routing policy configuration, see "Configuring routing policies."