H3C Technologies H3C SecPath F1000-E - Manual (Page 235)

210
Figure 119 Network diagram
Configuration procedure
The following describes only the configuration on the SecPath serving as a client.
# Configure GigabitEthernet 0/1 to dynamically obtain an IP address by using BOOTP.
system-view
[SecPath] interface GigabitEthernet 0/1
[SecPath-GigabitEthernet0/1] ip address bootp-alloc
# Use the display bootp client command to view the IP address assigned to the BOOTP client.
NOTE:
To make the BOOTP client obtain an IP address from the DHCP server, you must perform additional
configurations on the DHCP server. For more information, see "
Configuring DHCP server ."