H3C Technologies H3C SecPath F1000-E - Manual (Page 401)

376
[SecPathA-rip-1] import-route static
[SecPathA-rip-1] quit
[SecPathA] interface GigabitEthernet0/2
[SecPathA-GigabitEthernet0/2] rip bfd enable
[SecPathA-GigabitEthernet0/2] quit
[SecPathA] rip 2
[SecPathA-rip-2] network 192.168.3.0
[SecPathA-rip-2] quit
# Configure Router C.
system-view
[RouterC] rip 1
[RouterC-rip-1] network 192.168.2.0
[RouterC-rip-1] network 192.168.4.0
[RouterC-rip-1] peer 192.168.1.1
[RouterC-rip-1] undo validate-source-address
[RouterC-rip-1] import-route static
[RouterC-rip-1] quit
[RouterC] interface GigabitEthernet0/1
[RouterC-GigabitEthernet0/1] rip bfd enable
[RouterC-GigabitEthernet0/1] quit
# Configure Router D.
system-view
[RouterC] rip 1
[RouterC-rip-1] network 192.168.3.0
[RouterC-rip-1] network 192.168.4.0
[RouterC-rip-1] quit
2. Configure IP addresses and BFD parameters for the interfaces:
# Configure SecPath A.
[SecPathA] bfd session init-mode active
[SecPathA] interface GigabitEthernet0/1
[SecPathA-GigabitEthernet0/1] ip address 192.168.3.1 24
[SecPathA-GigabitEthernet0/1] quit
[SecPathA] interface GigabitEthernet0/2
[SecPathA-GigabitEthernet0/2] ip address 192.168.1.1 24
[SecPathA-GigabitEthernet0/2] bfd min-transmit-interval 500
[SecPathA-GigabitEthernet0/2] bfd min-receive-interval 500
[SecPathA-GigabitEthernet0/2] bfd detect-multiplier 7
[SecPathA-GigabitEthernet0/2] quit
# Configure Router B.
system-view
[RouterB] interface GigabitEthernet0/2
[RouterB-GigabitEthernet0/2] ip address 192.168.1.2 24
[RouterB-GigabitEthernet0/2] quit
[RouterB] interface GigabitEthernet0/1
[RouterB-GigabitEthernet0/1] ip address 192.168.2.1 24
# Configure Router C.
[RouterC] bfd session init-mode active