H3C Technologies H3C SecPath F1000-E - Manual (Page 142)

117
Step Command Remarks
4. Return to system view. quit N/A
5. Create a local user account
for the authenticator and
enter local user view.
local-user username N/A
6. Set the password for the local
user. password { cipher | simple }
password
The password of the authenticator
user must be the same as that of
the authenticatee user.
7. Configure the service type of
the local user as PPP.
service-type ppp N/A
NOTE:
•
For more information about local user configuration, see Access Control Configuration Guide.
• If the authenticator name is configured, do not configure the ppp chap password command on the
interface that connects the authenticatee. Otherwise, the authentication might fail.
Configuring CHAP authentication when no authenticator name
is configured
To configure the authenticator:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a VT interface and enter its
view.
interface virtual-template number N/A
3. Configure the local device to
authenticate the peer by using
CHAP.
ppp authentication-mode chap
[ [
call-in ] domain isp-name ]
By default, PPP
authentication is disabled.
4. Return to system view. quit N/A
5. Create a local user account for the
authenticatee and enter local user
view.
local-user username N/A
6. Set the password for the local user. password { cipher | simple }
password
N/A
7. Set the service type of the local
user to PPP.
service-type ppp N/A
8. Return to system view. quit N/A