Configuring the secpath – H3C Technologies H3C SecPath F1000-E User Manual
Page 287
262
Configuring the SecPath
# Specify the IP address of GigabitEthernet 0/2.
[SecPath] interface GigabitEthernet 0/2
[SecPath-GigabitEthernet0/2] ip address 192.168.10.100 255.255.0.0
The ping operation from Host A to Host B is unsuccessful because they are isolated at Layer 2.
# Configure local proxy ARP to implement Layer 3 communication between Host A and Host B.
[SecPath-GigabitEthernet0/2] local-proxy-arp enable
The ping operation from Host A to Host B is successful after the configuration.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer