Ipv6 pim-ssm configuration example, Network requirements – H3C Technologies H3C SecPath F1000-E User Manual
Page 916
891
Uptime: 00:03:39
Expires: 00:01:51
prefix/prefix length: FFDE::/16
RP: 8001::1
Priority: 192
HoldTime: 130
Uptime: 00:03:39
Expires: 00:01:51
prefix/prefix length: FFEE::/16
RP: 8001::1
Priority: 192
HoldTime: 130
Uptime: 00:03:39
Expires: 00:01:51
prefix/prefix length: FFFE::/16
RP: 8001::1
Priority: 192
HoldTime: 130
Uptime: 00:03:39
Expires: 00:01:51
IPv6 PIM-SSM configuration example
Network requirements
Receivers receive VOD information through multicast. The receiver groups of different organizations form
stub networks, and one or more receiver hosts exist in each stub network. The entire IPv6 PIM domain
operates in the SSM mode.
Host A and Host C are IPv6 multicast receivers in two stub networks, N1 and N2.
The SSM group range is FF3E::/64.
MLDv2 runs between SecPath A and N1 and between Router A/Router B and N2.
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer