H3C Technologies H3C SecPath F1000-E - Manual (Page 104)

79
Figure 51 Configure global MSTP parameters on SecPath
{
Select Enable from the Enable STP Globally list.
{
Select MSTP from the Mode list.
{
Select the Instance box.
{
Set the Instance ID field to 1.
{
Set the Root Type field to Primary.
{
Click Apply.
3. Configure Device A:
# Enter MST region view, configure the MST region name as example, map VLAN 10, VLAN 30,
and VLAN 40 to MSTI 1, MSTI 3, and MSTI 4 respectively, and configure the revision level of the
MST region as 0. (The procedure here is the same as that of configuring an MST region on
SecPath.)
# Enable MSTP globally and configure the current device as the root bridge of MSTI 3.
{
Select Network > MSTP > Global from the navigation tree, and make the following
configurations on the page similar to that shown in
Figure 51 .
{
Select Enable from the Enable STP Globally list.