Igmp configuration example in the web interface, Network requirements – H3C Technologies H3C SecPath F1000-E User Manual
Page 605
580
Figure 327 IGMP multicast group information of specific interface
Table 78 Field description
Field Description
Interface
Name of the interface that has joined the multicast group.
Group address
Multicast group address.
Group uptime
Length of time since the multicast group was reported.
Group remaining lifetime
Remaining lifetime of the multicast group. "null" means that the multicast
group times out when all multicast sources of this group time out.
Source address
Multicast source address.
Source uptime
Length of time since the multicast source was reported.
Source remaining lifetime
Remaining lifetime of the multicast source; null means that the multicast
source times out when the corresponding multicast group times out.
IGMP configuration example in the Web interface
Network requirements
As shown in
, receivers receive VOD information through multicast. Receivers of different
organizations form stub networks N1 and N2, and Host A and Host C are receivers in N1 and N2
respectively.
IGMPv2 runs between SecPath A and N1 and between SecPath B/SecPath C and N2. SecPath B serves
as the IGMP querier in N2 because it has a lower IP address.
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer