Yaskawa MP2000 Series: Built-in SVB or SVB-01 Motion Module - Manual (Page 42)

2.3 Mounting/Removing SVB-01 Modules
2.3.2 Removing SVB-01 Modules for Replacement
2-11
Settings and Installation
2.
Remove the cover of the SVB-01 Module.
Insert the tab of the battery cover into the slot on the top of the panel of the SVB-01 Module to release it, as
shown in the diagram. Turn the front of the battery cover towards you for this operation.
Release the bottom in the same way.
3.
Remove the SVB-01 Module from the mounting base.
Pull the top of the panel of the SVB-01 Module towards you to remove it. A notch on the SVB-01 Module will be
visible from the gap in the cover. Hook the round knob on the battery cover, shown in the diagram, into the notch
in the SVB-01 Module.
While holding the battery cover as shown in the photograph, tilt the cover back with the knob as the pivot point to
disconnect the Module. The Module should move forward out of the case.
Round Knob
Notch
Fulcrum