Yaskawa MP2000 Series: Built-in SVB or SVB-01 Motion Module - Manual (Page 280)

7.2 Motions After Switching Motion Commands
7.2.2 Switching from EX_POSING
7-10
7.2.2 Switching from EX_POSING
Switched From Switched To Operation
EX_POSING
NOP
EX_POSING will switch to NOP when the axis stops after deceleration.
POSING
09, bit 5 = 0)>
EX_POSING will switch to POSING when the axis stops after deceleration.
Incremental value = Target position − IL 14 (DPOS)
OL 1C = OL 1C + Incremental value
Any change in the Position Reference Setting (OL 1C) during deceleration
will be ignored.
09, bit 5 = 1)>
EX_POSING will immediately switch to POSING, and the moving amount stored in the
acceleration/deceleration filter will be maintained.
The set value of the Position Reference Setting (OL 1C) will be:
OL 1C = Target position
EX_POSING The EX_POSING operation will continue.
EX_POSING
Cancelled
EX_POSING
operation
EX_POSING NOP
EX_POSING NOP
Motion command
Motion command
response
Cancelled
EX_POSING
operation
EX_POSING
EX_POSING POSING
EX_POSING POSING
POSING
Motion command
Motion command
response
EX_POSING
Cancelled
EX_POSING
operation
EX_POSING POSING
EX_POSING POSING
The speed will smoothly change.
(The speed at the time the motion command
is switched will increase/decrease until it
reaches the target speed of POSING.)
The acceleration/deceleration filter will
remain valid.
POSING
Motion command
Motion command
response