Apple Soundtrack Pro 3 - Manual (Page 538)

3 Click Load Setup and follow the onscreen instructions.
Choosing a Configuration Saved with a Project
There may be a configuration saved along with a project you are using. If so, you can
choose to use that configuration with your Apogee hardware.
To use a configuration that is saved with the project
1 Confirm that your Apogee unit is connected and turned on.
2 Choose Soundtrack Pro > Open Apogee Control Panel.
The Apogee Setup dialog appears.
3 Click the Recall Setup From Project button at the bottom of the dialog and follow the
onscreen instructions.
This loads the configuration saved with the project.
538 Appendix D Working with Apogee Hardware in Soundtrack Pro