Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 99)

Network OS NETCONF Operations Guide 67
53-1003231-02
Installing or removing a license
6
Installing or removing a license
Refer to the Network OS Administrator’s Guide for procedures for installing and removing licenses.
You cannot install or remove licenses using the NETCONF interface.
Activating the Dynamic POD feature
To activate the Dynamic POD feature, complete the following steps.
1. Verify the current states of the ports with the custom RPC located in the
urn:brocade.com:mgmt:brocade-interface-ext namespace.
The and fields shown in bold typeface in the
following example indicate whether a port is licensed.
TenGigabitEthernet
22/0/1
TenGigabitEthernet
1/0/1
27
2500
2500
1/0/1
xmlns="urn:brocade.com:mgmt:brocade-interface">down
xmlns="urn:brocade.com:mgmt:brocade-interface">down
No DPOD License
(output truncated)
2. Install the Brocade Dynamic POD license.
For instructions on how to install a license, refer to “Installing or removing a license” on
page 67.
3. Disable and re-enable the ports.
Alternatively, you can disable and re-enable the chassis to activate ports.
4. Issue the custom RPC again to verify the newly activated ports and port
details.