Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 502)

470 Network OS NETCONF Operations Guide
53-1003231-02
Configuring Auto-QOS
29
Configuring Auto-QOS
Auto QoS (Quality of Service) for NAS creates a minimum bandwidth guarantee for Network
Attached Storage traffic. Auto QoS for NAS is disabled by default; you must enable Auto QoS to
allow NAS packets to have the correct service levels.
The cee-map priority group and priority-map settings must be their default values.
Enabling Auto QoS for NAS:
• Changes the CoS value of NAS packets to 2
• Reduces the weight of PGID 2 from 60 to 40
• Creates a new PGID 3 with a weight of 20
• Modifies the priority table to include PGID 3 for the user-configured NAS CoS, or the default
NAS CoS if the CoS has not been otherwise modified
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-qos namespace.
2. Enable Auto QoS for all NAS traffic with the NAS node under the container.
The presence of the node activates Auto-QOS.
3. Set the CoS value for all NAS traffic by entering a value for the node.
4