Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 378)

346 Network OS NETCONF Operations Guide
53-1003231-02
Spanning tree configuration and management
24
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include the node from the
urn:brocade.com:mgmt:brocade-xstp namespace.
3. Under the node, include the , , , , or node
element.
4. Under the , , , , or node, include the
node element.
5. Under the node, include the empty leaf element to enable
the error disable timeout.
Specifying the error disable timeout interval for all xSTP
For any spanning tree mode (STP, RSTP, MSTP, PVST, or Rapid PVST), use this procedure to specify
the time in seconds it takes for an interface to timeout. The range is 10 through 1000000 seconds.
The default is 300 seconds. By default, the timeout feature is disabled.
To specify the time in seconds it takes for an interface to timeout, perform the following steps.
1. Issue the RPC to configure the node in the
urn:brocade.com:mgmt:brocade-interface namespace.
2. Under the node, include the node from the
urn:brocade.com:mgmt:brocade-xstp namespace.
3. Under the node, include the , , , , or node
element.
4. Under the , , , , or node, include the
node element.