Brocade Network OS NETCONF Operations Guide v4.1.1 - Manual (Page 579)

Network OS NETCONF Operations Guide 547
53-1003231-02
Configuring a multigroup virtual router cluster
35
10
xmlns="urn:brocade.com:mgmt:brocade-ip-config">
1
192.53.5.1
tengigabitethernet
2/4
20
110
Configuring Router 1 as backup for second virtual router group
The following example RPC configures Router 1 as a backup for the second router
group. Make sure VCS Fabric mode is enabled, and then perform the following steps.
1. Establish a NETCONF session with Router 1.
2. To configure the VE interface link for Router 1, enable configuration of VE interface port 10.
3. Assign Router 1 to VRRP group 2.
4. Configure the Ethernet port 2/4 as the tracking port for VE port 10, with a track priority of 20.
VE port 10 will have its priority reduced to 20 should port 2/4 fail.
5. Configure 192.53.5.253 as the virtual IP address for group 2.
NOTE
For VRRP-E only, the virtual IP address cannot be the same as a real IP address configured on the
interface.